How do I get my charger into pairing mode?

To put your EV charger into pairing mode, follow these steps:

Turn Off and On:
- Begin by disconnecting the charger from the power supply.
- After a brief pause, reconnect the charger. This will activate pairing mode, which lasts approximately 60 seconds.
Connectivity Setup:
- Open your phone's Wi-Fi settings and search for available networks.
- Look for a network with the charger's serial number in the list. Note: Do not connect to this network; it's used for identification only.
Troubleshooting:
- If the charger's serial number does not appear, perform the following:
  - Power off the Wi-Fi router.
  - Disconnect the charger from the power supply.
  - After a short interval, reconnect the charger.
  - Note: Ensure the Wi-Fi router remains off during this process, as it may otherwise quickly connect to the charger and prevent the emission of a hotspot signal for pairing.