How do I commission an EVIQ charger using Bluetooth with the Installer Miles app?

How do I commission an EVIQ charger using Bluetooth with the Installer Miles app?

Here's a step-by-step guide:
  1. Open the Installer Miles App: Launch the Installer Miles application on your mobile device.

  2. Enable Bluetooth:
    Ensure that both Bluetooth and GPS are turned on in your mobile device's settings.

  3. Select Charger and Scan/Enter QR Code: In the app, select the EVIQ charger make and model. Then, either scan the QR code on the charger or
    manually enter charger’s serial number
    .

  4. Accept Bluetooth Pairing Request:
    After proceeding, a "Bluetooth Pairing Request" pop-up will appear. Enter PIN “123456” and tap "Pair" or "OK" to connect your device to the charger.

  5. Establish Bluetooth Connection: Your mobile device is now connected to the charger via Bluetooth.

  6. Set Up Network Connection:
    Now click on the network setup widget. Select Wi-Fi network setup button, enter the router password, and proceed.

    1. Choose 'Wi-Fi' in the network settings screen.
    2. Allow permission to access location services on your phone, if prompted. Ensure you enable location services in the device.
    3. You'll see a list of available networks; select yours. (2.4GHz)
    4. Enter your network password.
    5. Tap 'Connect'.
    6. If there's an error, double-check the Wi-Fi credentials.
    7. Tap 'Save'.

  7. Configuring the charger
    :
    Continue with the charger configuration setup as normal.
    This step involves configuring several key settings:

    1. Load Management: Configure how the charger will interact with the site's electrical system. This may involve setting current limits, configuring dynamic load balancing to prevent overloading, and ensuring safe and efficient power distribution.
    2. Installation Details: Specify the precise location of the charger. This is crucial for accurate mapping, maintenance, and potential integration with other services. The installer's email address must also be entered. Upon successful commissioning, the customer will receive an email notification confirming that the charger is ready for use.
    3. Smart Regulations Setup: The Charger Restriction option allows you to temporarily disable restrictive hours on the charger. If you're installing chargers during peak hours (8-11 am and 4-10 pm), you can disable these hours to conduct tests efficiently. It's important to note that disabling restricted hours will make the charger non-compliant with smart regulations until you re-enable them.

  8. Proceed to commissioning:
    When you are ready, tap the "Next" button at the bottom of the screen to start the commissioning process.

  9. Wait for Commissioning:
    The data transfer and commissioning process will take approximately 1 to 3 minutes. It is crucial to maintain the connection and not interrupt the process.

  10. Commissioning Complete: Once the process is finished, the app will automatically display the successful installation screen, indicating that the charger is ready for use.
Important Note: After successful commissioning, the charger may take an additional 1 to 2 minutes to complete its boot-up sequence.